| WlanIf |
| The index of WLAN interface the table entry corresponds to. |
| WlanIfType |
| This value specify that the scan properties is used for AP, client or wds. |
| Type |
| This variable specifies how to perform a WLAN scan. off := disable each kind of scanning (default in AP-Mode) background := The scan takes place during an active connection, than means the radio hops between home and foreign channel (default in Client-Mode) foreground := The current connection is interrupted while scanning |
| OperState |
| Current status of the scanning off := No scan scheduled or in progress idle := Scheduled but not yet started scanning := The radio is currently in scan mode |
| Options |
| passive := enable passive scan-mode (default in AP-Mode) active := enable active scan-mode, Prop-Request will be send out (default in Client-Mode) dot11a := enable scanning on 5Ghz Channels (default) dot11bg := enable scanning on 2,4Ghz Channels (default) |
| MaxDuration |
| Maximal duration in ms how long a scan should take (default 50s). |
| DwellActiveMin |
| Minimal duration in ms how long we dwell on a channel during a active scan. |
| DwellActiveMax |
| Maximal duration in ms how long we dwell on a channel during a active scan. |
| DwellPassiveMin |
| Minimal duration in ms how long we dwell on a channel during a passive scan. |
| DwellPassiveMax |
| Maximal duration in ms how long we dwell on a channel during a passive scan. |
| HomeDwellMin |
| Minimal duration in ms how long we dwell during a background scan on our home-channel. (default is 250 for AP-Mode and 50 for Client-Mode) |
| HomeDwellMax |
| Maximal duration in ms how long we dwell during a background scan on our home-channel. |
| Interval |
| Time in ms between each scan. (default is 1h for AP-Mode) |
| LastScan |
| Timestamp of the last finished scan. |
| ClientThreshold |
| Threshold in dBm above which the client mode background scan is active. Default is -70dBm. |
| ClientRoamProf |
| All scanning parameters for the client are summarized to profiles for the most used roaming behaviors. fast : client roams if signal is not strong enough for higher data rates normal: default roaming parameters slow : client roams if signal is weak no : client roams only when it is disassociated custom: user can change roaming parameter |