| IfIndex |
| ifIndex of the WLAN Interface the scan results belong to. |
| Index |
| Auxiliary index for different BSS entries. |
| BSSID |
| BSSID of this BSS. Length: 6 to 6 |
| Age |
| Age of this BSS entry. |
| RSSI |
| Receive signal strength of this BSS. Range: -110 to 0 |
| SSID |
| SSID aka network name of this BSS. If broadcasting of SSID is disabled on this BSS, this string may be empty. Length: 0 to 255 |
| Channel |
| The channel where this BSS send its beacon on. Range: 1 to 256 |
| DTIMPeriod |
| The number of DTIM intervals between the start of CFPs for this BSS. Range: 0 to 255 |
| BeaconPeriod |
| This attribute contains the number of TU that this BSS uses for scheduling Beacon transmissions. Range: 1 to 65535 |
| CapInfo |
| The number of DTIM intervals between the start of CFPs for this BSS. |
| Rates |
| This attribute contains one octet for each supported rate in this BSS, in 500 Kbps units. |
| BasicRates |
| This attribute contains one octet for each required basic rate in this BSS, in 500 Kbps units. |
| ExtendedRates |
| This attribute contains one octet for each supported extended rate in this BSS, in 500 Kbps units. |
| FrameData |
| This attribute contains raw data from 802.11 beacon or probe response frames, starting with the 802.11 timestamp. |
| Type |
| This attribute contains the device type of the scanned device. Enumerations: - access-point (1)
- ad-hoc (2)
|
| Privacy |
| This attribute contains the privacy type of the scanned device. Enumerations: - none (1)
- wep (2)
- wpa-psk (3)
- wpaandwpa2-psk (4)
- wpa2-psk (5)
- wpa-enterprise (6)
- wpaandwpa2-enterprise (7)
- wpa2-enterprise (8)
|
| WPAUnicastCipher |
| This attribute contains the WPA unicast ciphers of the scanned device. Enumerations: - cipher-none (0)
- cipher-wep40 (1)
- cipher-wep104 (2)
- cipher-tkip (3)
- cipher-aes (4)
|
| RSNUnicastCipher |
| This attribute contains the RSN unicast ciphers of the scanned device. Enumerations: - cipher-none (0)
- cipher-wep40 (1)
- cipher-wep104 (2)
- cipher-tkip (3)
- cipher-aes (4)
|
| RSSI1 |
| Receive signal strength of this BSS at first receiver. Range: -110 to 0 |
| RSSI2 |
| Receive signal strength of this BSS at second receiver. A value of 0 indicates no second receiver present. Range: -110 to 0 |
| RSSI3 |
| Receive signal strength of this BSS at third receiver. A value of 0 indicates no third receiver present. Range: -110 to 0 |
| FirstSeen |
| The timestamp, when this known AP was first seen. |
| LastSeen |
| The timestamp, when this AP was last seen. |
| Signal |
| Receive signal strength of this BSS. Range: -110 to 0 |
| WPAMulticastCipher |
| This attribute contains the WPA multicast cipher of the scanned AP. |
| RSNMulticastCipher |
| This attribute contains the RSN multicast cipher of the scanned AP. |
| Bandwidth |
| Used bandwidth of this BSS. |
| FirstChannel0 |
| First channel in ieee notation of the first band. |
| FirstChannel1 |
| First channel in ieee notation of the second band. This is used on 80MHz+80MHz in .11ac mode. Value 0, if this field is not used. |
| Mode |
| Used mode of this BSS. |